Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guía de instalación descargar pdf (Pagina 78)

2. Modify the driver conﬁguration ﬁle

/platform/i86pc/kernel/drv/cnft.conf.

This ﬁle speciﬁes the valid conﬁgurable parameters for the driver:

duplex_mode: This property forces the duplex mode for the controller. It can

be set to:

0 - Autoconﬁgure (Default)

1 - Half duplex

2 - Full duplex

media_speed: This property sets the media speed for the controller. This

option can be used to force the 10/100BASE-TX to 10- or 100-Mbps operation.

The media speed is autoconﬁgured by default. The valid values are:

0 - Autoconﬁgure (Default)

10 - Force 10-Mbps media speed

100 - Force 100-Mbps media speed

max_tx_lsts, max_rx_lsts, tx_threshold: These properties tune driver

performance. The valid values are:

Property Valid Values Default Value

max_tx_lsts

4to16 16

max_rx_lsts

4to16 16

tx_threshold

2to16 16

debug_flag: Set this property to 1 or 0 to enable or disable debug messages

from the driver. Debug messages are disabled by default.

mediaconnector: Set to 1 to enable the AUI interface for the Integrated

NetFlex-3 controller on ProLiant 2500 systems or to enable the BNC interface

on the Integrated NetFlex-3 controller on the ProLiant 800, Deskpro 4000/6000,

and Professional Workstation 5000. The UTP interface is the default (0).

board_id: Set this property to support additional EISA/PCI controllers. The

format of the board_id is 0xVVVVDDDD, where VVVV means vendor ID

and DDDD, device ID. More than one ID can be speciﬁed, if required.

3. To activate the conﬁguration changes, as root type:

# touch /reconfigure

# reboot

66 Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 126 127

Sin comentarios

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guía de instalación Pagina 78