
Compaq SMART-2, SMART-2SL,
SMART-2DH Array Controllers
Solaris Device Driver:
smartii
Device Type:
Disk Array
Adapters:
Compaq SMART-2, SMART-2SL, SMART-2DH
Array Controllers
Bus Types:
EISA, PCI
Systems Supported:
Internal and external SCSI drives on Compaq
servers
Preconfiguration Information
These controllers only support SCSI disk drives. SCSI tape drives and CD-ROM
drives are not supported.
The boot device must be logical drive 0 on the primary controller. Even though the
BIOS lets you configure any controller as the primary controller, it will only let
you boot from logical drive 0 on that controller.
EISA systems only: Configure the system using the Compaq EISA configuration
utility (at least ECU version 2.30) so the system recognizes the SMART-2 controller.
Known Problems and Limitations
If disks on a failed drive are replaced by hotplugging during I/O, the system
panics.
Firmware version 1.26 of the SMART-2 PCI controller is slow. For best results, use
firmware version 1.36.
Device Reference Pages 45
Comentarios a estos manuales