
Use edge-triggered interrupts on the PM-2011.
The PM-2041W adapter’s SmartROM must be upgraded to at least version 3DL in
place of 3D0. The BIOS on adapters with version 3D0 does not detect any devices
connected to it.
Known Problems and Limitations
The DPT adapter may cause the Solaris installation to fail due to loss of interrupts,
depending on the setting of jumper Y34. If the installation fails, try changing the
setting of jumper Y34 (even if the on-board diskettes have already been disabled
by removing jumper Y20).
The dpt driver only detects the PM-2041W adapter at address 0x230; therefore,
dual card mode does not work.
Device Reference Pages 31
Comentarios a estos manuales