Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guía de instalación descargar pdf (Pagina 59)

Known Problems and Limitations

To prevent system hangs caused by improper IDE emulation, the EISA

!DPTA410.CFG ﬁle should be at least version 6E5. If it isn’t, obtain a newer

version from your vendor and rerun the EISA conﬁguration utility.

Solaris installation may fail when setting up the fdisk partition table on one or

more disks. On systems with a disk RAID conﬁguration where at least one disk is

new or has had its partition table zeroed out, these error messages may be

displayed. If the Solaris installation fails and you see the following error messages,

restart the installation. It should succeed.

ERROR: Could not create Fdisk partition table on disk

ERROR: Could not label the disks

Use the original install diskette when adding a PM-3222 to your system.

Conﬁguration Procedure

Run the DPT SCSI Storage Manager Utility, DPTMGR, under DOS, and select Solaris

as the operating environment. See Chapter 4 of DPT SmartCache III User’s Manual for

instructions. An error message similar to this may be displayed while DPTMGR is

running.

Unable to find any drivers in the DRIVERS Directory ......

This message can be ignored.

Special Cases

When using the ECU supplied by DPT in conjunction with a conﬁguration ﬁle, you

enter emulation information as part of the conﬁguration process. When you

conﬁgure two drives, both should be “disabled.” When asked for drive types for

drives 0 and 1, type 0. This indicates “no drives present” and disables the WD1003

emulation mode of the adapter, allowing correct operation of the native mode driver.

Device Reference Pages 47

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 126 127

Sin comentarios

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guía de instalación Pagina 59