Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guía de instalación Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 127
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
to “To ISA Legacy IRQs”. A similar workaround may apply to other motherboards
with problems supporting channel B.
Another possible workaround is noted on Adaptec’s Web site at
http://www.adaptec.com/support/faqs/aha394x.html.
To use the AHA-3940 or AHA-3940W adapters, the motherboard must have a
BIOS that supports the DEC PCI-to-PCI Bridge chip on the host bus adapter.
User-level programs have exhibited problems on some PCI systems with an
Adaptec AHA-2940x card, including the following motherboard models:
PCI motherboards with a 60-MHz Pentium chip, with PCI chipset numbers
S82433LX Z852 and S82434LX Z850. The part numbers of the Intel
motherboards are AA616393-007 and AA615988-009.
PCI motherboards with a 90-MHz Pentium chip, with PCI chipset numbers
S82433NX Z895, S82434NX Z895, and S82434NX Z896. The part number of the
Intel motherboard is 541286-005. (Some Gateway 2000 systems use this
motherboard.)
The AA-619772-002 motherboard with 82433LX Z852 and 82434LX Z882 chips
causes random memory inconsistencies. Return the motherboard to the vendor
for a replacement.
If problems with user-level programs occur, use the BIOS setup to turn off
write-back CPU caching (or all caching if there is no control over the caching
algorithm).
If the AHA-2940 SCSI adapter does not recognize the Quantum Empire 1080S HP
3323 SE or other SCSI disk drive, reduce the Synchronous Transfer rate on the
Adaptec controller to 8 Mbps.
The AHA-3940 has been certified by Adaptec to work on specific systems. Our
testing has shown that the Solaris operating environment works properly in some
of those systems and not in others. If you encounter problems running the Solaris
operating environment on an Adaptec-approved system with the AHA-3940,
contact your technical support provider.
Configuration Procedure
Using the Adaptec configuration utility:
Configure each SCSI device to have a unique SCSI ID, and on the adapter’s
Advanced Configuration Options setup menu, set the Plug N Play SCAM Support
option to Disabled.
If there is more than one controller (or an embedded controller), try to use one
IRQ per controller.
Enable bus mastering for the slots with your host bus adapters, when the choice is
given.
18
Device Reference Manual for Solaris 2.6 (Intel Platform Edition) April 1998
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 126 127

Comentarios a estos manuales

Sin comentarios