
Address space At least 8 Kbytes are required with 4 Kbytes per socket
in the 640K-1MB range (not necessarily contiguous); if
there are three sockets, at least 12 Kbytes are needed
I/O space At least 8 and preferably 16 bytes per socket
IRQs One per socket, plus an IRQ for the pcic device
driver itself
Configuration Procedure
Initial Installation and Configuration
1. Consult the Configuration Assistant for address space, I/O space, and IRQs
already used by system devices.
2. Insert the PC Card adapter.
3. Install the Solaris software, including the PCMCIA packages in the SUNWpcmc
cluster.
If you choose to install the Entire Distribution, the PCMCIA packages are
automatically included. After installation and reboot, any reconfiguration is
done automatically.
If you choose any other distribution, such as the End User Distribution, select
Customize from the choices at the bottom of the Software Selection screen.
Then choose PCMCIA Support from the scrolling list on the Customize
Software screen. After installation and reboot, any reconfiguration is done
automatically.
4. Reboot the system.
Adding PC Card Support to a Previously Installed System
1. Become root.
2. Use the pkgadd command and select PCMCIA Support from the Customize
Software screen.
3. Do a reconfiguration reboot to reallocate resources:
102
Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998
Comentarios a estos manuales