
DPT PM-2011, PM-2021, PM-2041W,
PM-3021 HBAs
Solaris Device Driver:
dpt
Device Type:
SCSI
Adapters:
DPT PM-2011, PM-2021, PM-2041W, PM-3021
Bus Type:
ISA
Preconfiguration Information
The EPROM should not be earlier than version 5E, and the SmartROM should not
be earlier than version 2.C.
Only two DPT adapters can be used per system.
If two adapters are installed, do not install an IDE controller.
If an IDE controller is installed, only one DPT adapter will be supported.
Supported Settings
You must use the settings in this typeface for the DPT adapter if an IDE controller is
installed:
• I/O Address: 0x1F0, 0x230
• IRQ Level:
12, 14, 15
• DMA Channel: 5, 6
• Emulation:
Disabled
Follow the instructions in “DPT PM-2022, PM-2042W, PM-2122, PM-2142W SCSI
and PM-3222, PM-3332UW SCSI RAID HBAs” on page 46 to disable WD1003
emulation using the DPT SCSI Storage Manager Utility diskette.
Emulation mode for drives 0 and 1 should be set to 0 indicating “no drives
present,” or there will be missing drives when the system boots.
30
Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998
Comentarios a estos manuales