
Compaq NetFlex-2 DualPort ENET,
NetFlex-2 ENET-TR Controllers
Solaris Device Driver:
nfe
Device Type:
Network (Ethernet and token ring)
Adapters:
Compaq NetFlex-2 DualPort ENET,
NetFlex-2 ENET-TR
Bus Type:
EISA
Preconfiguration Information
Supported Settings
• IRQ Level: 3, 5, 9, 10, 11
Both ports on the Compaq NetFlex-2 DualPort ENET card share the same IRQ.
Known Problems and Limitations
Although the NetFlex-2 ENET-TR controller can be configured for Ethernet or
token ring, Solaris software only supports the Ethernet functionality.
Promiscuous mode is not supported by the firmware for this card.
Configuration Procedure
1. Set the connector type; use DB-15 or 10BASE-T RJ-45.
Use the splitter cable (shipped with the DualPort ENET controller) with DB-15
connectors.
If the DualPort ENET card is used to install the Solaris software over a
network, connect the RJ-45 connector to the first network port (Port 1).
62
Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998
Comentarios a estos manuales