
Troubleshooting the SIERRA™ plus film digitizer 72
VIDAR Film Digitizer Installation Guide
Turning the digitizer on and off
WARNING
Do not apply power by plugging the DC power connector into
the digitizer while the power supply is live. Do not remove
power by unplugging the DC power connector from the digitizer
while the power supply is live. Either of these actions could
permanently damage the digitizer, the power supply or both.
Note:
SIERRA was designed to be powered continuously.
Under normal conditions, the digitizer should remain on at all
times.
Use only the power switch to turn the digitizer on or turn it off:
The power switch is located behind the upper right corner of the digitizer
(when viewed from the front).
Comentarios a estos manuales