Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación descargar pdf (Pagina 17)

VIDAR Film Digitizer Installation Guide

Configuring SCSI settings

for the SIERRA™ plus film digitizer

In this chapter, you will:



Set the digitizer’s SCSI ID number.



If necessary, activate the digitizer’s SCSI termination.



Record important information about the digitizer.

1. Set the digitizer’s SCSI ID

A computer equipped with a SCSI bus can communicate with multiple

SCSI devices (for example: a film digitizer, a scanner and a disk drive).

Each device must have a unique SCSI ID number so the computer can

distinguish it from other SCSI devices. Valid SCSI ID numbers range

from 1 to 6.

When selecting SCSI ID numbers:



The SCSI Card 2930U is preset to SCSI ID 7 and should not be

changed.



Set the film digitizer to any SCSI ID between 1 and 6, as long as that

number is not used by another SCSI device attached to the computer.

Note:

The SIERRA™ plus is shipped from the factory with the

SCSI ID preset to 3.



If the system is configured to boot from a SCSI disk drive, it’s best to

set the disk’s SCSI ID to 0 or 1. Most SCSI disks are preset to SCSI

ID 0 at the factory.

continued

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 85 86

Sin comentarios

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación Pagina 17