
Configuring SCSI settings for the SIERRA™ plus film digitizer 16
VIDAR Film Digitizer Installation Guide
CAUTION:
The digitizer and computer MUST be turned OFF
before changing the SCSI ID.
To set the digitizer’s SCSI ID:
a. Locate the switch adjusting tool.
b. Lay the digitizer on its back, with its bottom surface toward you.
c. Locate the SCSI ID switch.
d. Use the tool’s flat tip to rotate the SCSI
ID switch to the desired SCSI ID number.
Note:
Do not set the switch to position
0
,
7
,
8
or
9
, as these are
not valid
SCSI ID numbers.
CAUTION:
Do not force switch rotation. Do not use a large
screwdriver to rotate the switch.
SCSI ID switch
Bottom of digitizer
Comentarios a estos manuales