Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación Pagina 4
- Pagina / 86
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
2
VIDAR Film Digitizer Installation Guide
VIDAR Part Number 15247-001 Rev. A
January, 2002
© Copyright 2002 by VIDAR Systems Corporation. All rights reserved.
Printed in the USA.
No part of this publication may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, electronic, mechanical, photocopying,
recording or otherwise, without the prior written permission of VIDAR Systems
Corporation.
Terms denoted by the trademark symbol ( or ®) used in this publication are trademarks
or service marks registered in the United States or other countries.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area can cause harmful interference, in which case the user will be required
to correct the interference at his or her own expense.
Product compliance testing was conducted using VIDAR shielded cables. Modifications
to VIDAR shielded cables or the use of cables other than those available from VIDAR
could void the user’s authority to operate the equipment.
SIERRA™ plus carries the CE mark, issued by G-MED (registration number 0459) in
accordance with EC-MDD directive 93/42/ECC.
Caution: No operator-serviceable parts inside. Refer servicing to qualified personnel.
Achtung: Gehäuse nicht öffnen. Wartung uno reparatur nur durch eletrofachkräfte.
Attention: Aucune piece ne peut etre remplacee par l’utilisateur. Toute operation de
maintenance doit etre effectuee par une personne qualiee.
Atencion: Acceso interno solo autorizado a personal tecnico cualificado.
Attenzione: Non appire. Rivolgersi a personale qualificado.
460 Spring Park Place
Herndon, VA 20170 U.S.A.
Sales: 1-800-471-SCAN or 1-800-471-7226
Email: s[email protected]om
Phone: (703) 471-7070
Fax: (703) 471-7665
Internet: www.filmdigitizer.com
Technical Support:
1-888-INFO-471 or 1-888-463-6471
E-mail: medtech@vidar.com
Authorized representative
in Europe
Emergo Europe
P.O. Box 149
4300 AC Zierikzee
The Netherlands
Phone: (31) 1114 11515
Fax: (31) 1114 10104
Email: i[email protected]
- Documentation questionnaire 1
- Comments are from 2
- Installation guide for 3
- Contents 5
- Unpacking 7
- 3. Identify the parts 12
- 4. Remove the shutter lock 15
- 5. If anything is missing 16
- Configuring SCSI settings 17
- SCSI ID switch 18
- Bottom of digitizer 18
- Table-top stand 22
- CAUTION: 24
- Pinch point 24
- Tighten by hand only 24
- 2. Mount the digitizer 25
- SAFETY WARNING 27
- 4. Connect the power cable 28
- 5. Connect the SCSI cable 29
- 6. Install the exit tray 30
- 7. Install the feed tray 31
- Multi-film feed tray cable 32
- To dig iti zer 33
- Power supply 33
- Power cord 33
- Wall mounting 34
- 1. Select proper wall space 35
- WARNING 39
- 4. Mount the digitizer 40
- 5. Connect the power cable 42
- 6. Connect the SCSI cable 43
- 7. Install the exit tray 44
- 8. Install the feed tray 45
- Installing SCSI hardware 48
- 2. Install the SCSI card 50
- Installing SCSI software 52
- Computers with Windows 2000 54
- Computers with Windows 98 56
- Computers with Windows 95 57
- Using the SCSI Utility 59
- Operating 62
- About films 64
- Loading a single film 65
- Loading multiple films 67
- Troubleshooting 69
- In case of difficulty 70
- Operational problems 71
- Appendix 76
- Warranty information 77
- End user information 79
- End user technical contact 79
- System configuration 80
- CD-ROM drive 81
- CD-R/W drive 81
- Diskette drive 81
- Serial ports 82
- USB ports and hub 82
- Parallel ports 82
- Video adapter 83
- Display 83
- SCSI adapters 83
- SCSI devices 84
- Digitizer 84
- Software 85
- Operating system 85
- Scanning software 85
- Scanning parameters 85
Relacionado con productos y manuales para No Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps
No Adaptec AVA-1505A Guía de usuario
(33 paginas)
(33 paginas)
No Adaptec APA-1480 Manual de usuario
(24 paginas)
(24 paginas)
No Adaptec 1394 Guía de usuario
(80 paginas)
(80 paginas)
No Adaptec AHA-2930CU Guía de instalación
(68 paginas)
(68 paginas)
No Adaptec ASA-7211C/F Guía de usuario
(12 paginas)
(12 paginas)
No Adaptec 3940UW Guía de usuario
(82 paginas)
(82 paginas)
No Adaptec 1742A Manual de usuario
(9 paginas)
(9 paginas)
No Adaptec SBC-596 Manual de usuario
(91 paginas)
(91 paginas)
No Adaptec ASH-1233 Manual de usuario
(17 paginas)
(17 paginas)
No Adaptec APA-460 Guía de instalación
(58 paginas)
(58 paginas)
No Adaptec 39160 Guía de instalación
(38 paginas)
(38 paginas)
No Adaptec APA-358 Guía de instalación
(12 paginas)
(12 paginas)
No Adaptec AFW-1430 Guía de usuario
(22 paginas)
(22 paginas)
No Adaptec 1742A Manual de usuario
(68 paginas)
(68 paginas)
No Adaptec ACB-2010A Manual de usuario
(9 paginas)
No Adaptec 2940UW Guía de usuario
(50 paginas)
(50 paginas)
No Adaptec 9110G Especificaciones
(38 paginas)
(38 paginas)
No Adaptec AHA-1520A Guía de instalación
(8 paginas)
(8 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales