Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación descargar pdf (Pagina 57)

Installing SCSI software for the SIERRA™ plus film digitizer 55

VIDAR Film Digitizer Installation Guide

Computers with Windows 95

Windows 95 has two versions. Use the corresponding steps below.

If the “New Hardware Found” window appears...

1. Select Driver from disk provided by hardware manufacturer.

2. Insert the Adaptec Driver Installer diskette into the diskette drive.

3. In the Install from Disk window, type

a:\win95

. Windows will install

the required driver.

4. After the installation is finished, remove the diskette.

5. Go to “Using the SCSI Utility,” later in this chapter.

If the “Update Device Driver” wizard appears...

1. Insert the Adaptec Driver Installer diskette into the diskette drive.

2. Click Next.

3. The Device Driver Wizard will not detect the driver. Click Other

Locations, then type

a:\win95

4. Windows detects the host adapter as the Adaptec AHA-2930U PCI

SCSI Controller. Click Finish.

5. When prompted to install the Adaptec Driver Installer diskette, then

click OK.

6. When prompted for the location of the drivers, type

a:\win95

, then

press

ENTER

7. After the installation is finished, remove the diskette.

8. Go to “Using the SCSI Utility,” later in this chapter.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 85 86

Sin comentarios

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación Pagina 57