
20
VIDAR Film Digitizer Installation Guide
Table-top stand
for the SIERRA™ plus film digitizer
The table-top stand is for use in situations where the SIERRA™ plus
film digitizer cannot be mounted on a wall. The stand was designed to
be placed on a table, desk or countertop up to 36" (91cm) high.
SAFETY WARNING
Never place the SIERRA™ plus with table-top stand on the floor.
In brief, to assemble the SIERRA™ plus film digitizer with the table-top
stand you will:
Assemble the stand and mounting bracket.
Install the digitizer on the mounting bracket.
Place the stand-mounted digitizer in a suitable working location.
Attach power and SCSI cables.
Install the exit tray.
Instructions are provided in this chapter.
Before you start...
Be sure you have already set the SCSI ID and SCSI termination
switches (see the “Configuring SCSI settings” chapter, earlier in this
manual). It’s easier to see and set these switches before the digitizer is
attached to the table-top stand.
Comentarios a estos manuales