Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación descargar pdf (Pagina 67)

Operating the SIERRA™ plus film digitizer 65

VIDAR Film Digitizer Installation Guide

Loading multiple films

The SIERRA™ plus can accept up to 10 films of mixed sizes.

CAUTION:

Do not load more than 10 films at one time.

1. Ensure the LED on the front of the digitizer is solid green.

2. Hold the film stack in front of you as you would view the films on a

light box.

Films at the back of the stack are digitized first.

3. Align the left edge of the film stack with

the film guide on the left edge of the

feeder.

4. Place the film stack IN the blue area.

The blue area is defined by a lip and a

groove below the feed tray. Place the film

stack in front of the feeder inside the

groove of the blue area.

Note:

If you are digitizing a single film,

place the film

BEHIND the blue area

When the SIERRA™ plus detects the first

film, it stages the film—it pulls the film in

about 1" (2.5cm), then pushes the film back

out about 1/2" (1.25cm).

continued

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 85 86

Sin comentarios

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guía de instalación Pagina 67