
Chapter 2 Deploying the MetaFrame Servers and ICA Clients 25
8. From Third-party Drivers, click Yes to proceed. If you receive the message
“The driver is already installed on the system” and are asked to use the current
or new drivers, click New.
9. If prompted for the driver diskette a second time, click Continue.
10. When you receive the message “The drivers were successfully installed,”
remove the display driver diskette, then click OK.
11. Click Close twice.
12. Click Yes to reboot the server.
IBM PC Server 330
This application note describes how to install MetaFrame on an IBM PC Server
330 system.
The IBM PC Server 330 is a high-speed, upgradeable PC server-class system with
large data storage capacity and improved system expandability. The PC Server
330 provides both Extended Industry-Standard Architecture (EISA) and high-
performance Peripheral Component Interconnect (PCI) expansion slots.
Software Requirements
K
MetaFrame Version 1.8 for Windows 2000
K
Microsoft Windows 2000 with Terminal Services installed
K
IBM PC ServeRAID Device Driver and Utilities Version 1.40
Installing MetaFrame
1. Install Windows 2000 following the directions in the Microsoft documentation.
2. When prompted whether to autodetect mass storage controllers , press S to
skip mass storage detection and S again to specify additional SCSI adapters.
3. Insert the IBM ServeRAID Device Driver and utility diskette, press ENTER
until the IBM PC ServeRAID Adaptor is displayed. Press ENTER to accept
the driver and then press ENTER to continue.
4. Complete Windows 2000 installation.
5. After the system reboots, log on to the Windows 2000 console as an
administrator.
6. Insert the MetaFrame compact disk into the CD-ROM drive and begin
installing MetaFrame following the instructions in the Citrix MetaFrame
documentation.
Comentarios a estos manuales