Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Información técnica Pagina 158

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 186
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 157
144 MetaFrame Solutions Guide
Packeteer requires some knowledge to get the full benefit from the device.
Packeteer allows you to monitor the traffic traveling across the link and then apply
policies to that traffic depending upon mission criticality of the protocols or traffic
classes. Included in this note are the directions to set up Packeteer to recognize the
ICA protocol and start tracking it. You can toggle packet shaping on and off to see
the effect that it has on network traffic.
Requirements
Hardware Requirements
K
WINFRAME or MetaFrame server
K
WAN Setup
Software Requirements
K
WINFRAME Version 1.7 or later
K
MetaFrame Version 1.0 or later
K
PacketShaper Version 3.0 or later
Installation
Below are the instructions to set up a PacketShaper running Version 3.0 to
recognize and prioritize ICA traffic. For Version 3.1, Packeteer has built-in
recognition for Citrix W
INFRAME/MetaFrame, so when traffic autodiscovery is on,
PacketShaper detects W
INFRAME/MetaFrame ICA and server balancing traffic and
automatically creates classes for both. To determine what version you are running,
log on to PacketShaper using the Web interface. Version information is in the top
right corner of the PacketShaper Policy Console home page.
1. Make sure your PacketShaper is correctly configured and is functioning on
your network. In your configuration (the Setup option of the PolicyConsole
navigation bar), make sure that Traffic Discovery is turned on. If you have any
questions about this, please contact Packeteer technical support at
[email protected] or (408) 873-4550.
2. Create a class for Inbound Citrix W
INFRAME/MetaFrame traffic:
A. Click the Manage option of the PolicyConsole navigation bar.
B. Click Inbound in the Traffic Tree in the left side of the Manage dialog
box.
C. Click Class... in the New area in the right hand side of the Manage Traffic
Tree dialog box. This creates a child class on the inbound branch of the
traffic tree.
Vista de pagina 157
1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 185 186

Comentarios a estos manuales

Sin comentarios