Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Información técnica descargar pdf (Pagina 175)

Chapter 7 Troubleshooting the System 161

Configuring the Host Computer for Debugging

The host computer set up is similar whether the host computer is used in a local,

remote, or ICA debug configuration. There are four steps to the set up process:

Installing symbols

Preparing the COM port and optional modem

Installing and configuring the kernel debugger

Running the kernel debugger

Installing Symbols on the Host Computer

To effectively debug the target computer, the host computer must have access to a

set of symbol files that exactly correspond to the files installed on the target

computer. Because the system files installed on the host may not match the system

files installed on the target (and are not required to), the symbol tree on the host

must be in a directory other than the host’s %SystemRoot% directory. Citrix

recommends creating a \Debug directory on the host computer with subdirectories

for each version of the symbol tree; for example the tree containing the symbols

for MetaFrame Version 1.8 for Windows 2000 might be named \Debug\MF18

\Symbols. Follow the same procedures used to install the symbol files on the

target computer to install symbols on the host computer, except that where the

procedure refers to the %SystemRoot% directory on the target computer, use the

\Debug directory on the host computer instead.

ÛÛ

Û To install the debugging symbols on the host computer

1. Create a \Debug directory on the host computer. Create a subdirectory for each

version of the symbol tree; for example \Debug\MF18\Symbols.

2. Insert the MetaFrame CD-ROM into a CD-ROM drive that can be accessed by

the target computer. Use xcopy to copy the \Support\Debug\I386\Symbols

directory and its subdirectories from the MetaFrame CD-ROM to the directory

created in Step 1; for example: xcopy /v /s x:\support \debug\i386\symbols

d:\debug\mf18\symbols, where x is the CD-ROM drive.

3. If you are installing hotfixes, copy the symbol files corresponding to the new

binaries in the hotfix to the \Symbols directory of the target computer.

4. When you are done installing the symbols, configure the target system for

debugging.

Preparing the Host Computer Modem and COM Port

As with the target computer, the next step is to configure the COM port and the

optional modem (remote debug only) on the host computer. Local and ICA debug

configurations use a null-modem connection between the target and host

computers and do not need modem configuration. Remote debug configurations

require modem configuration.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 185 186

Sin comentarios

Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Información técnica Pagina 175