
5-48
Adaptec SCSI RAID Software Reference Guide
multilevel array of volume sets after you extend it, as in the
following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 40MB NTFS
63 Volume 10MB 0:02:0 64.0KB: 10.0MB
62 Volume 15MB 0:03:0 64.0KB: 15.0MB
61 Volume 15MB 0:04:0 64.0KB: 15.0MB
The following list describes the change to the display as the result of
extending a multilevel array with the container extend
mvolume
command:
■ The Num Label column continues to display the ID number
(0) of the volume set previously created with the container
create volume
command and the ID number (63) of the
volume set previously created with the container
add_level
command. In addition, the column displays the
ID numbers (in this example, 62 and 61) of the volume sets
created as a result of the container extend mvolume
command.
If you specified labels when creating the volume sets, they
appear in this column. Because no labels were specified when
the volume sets were created, no labels appear in the column.
■ The Type column continues to display Volume to indicate that
the arrays previously created with the container create
volume
and the container add_level commands are
volume sets. In addition, the column displays Volume for the
volume sets created as a result of the
container extend
mvolume command.
■ The Total Size column displays a new total size, taking into
account the freespaces associated with the volume sets created
as a result of the container create volume
and the
container add_level commands.
■ The Scsi C:ID:L column displays the SCSI IDs for the devices
on which the volume sets were created, which in the example
are 0:02:0, 0:03:0, and 0:04:0.
Comentarios a estos manuales