Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 89)

5-41

container Commands

/unconditional{=boolean}

Specifies whether to delete the array, even if the array has open

files on it. If you specify TRUE, the command deletes the array

even if it has open files on it.

The switch defaults to FALSE (that is, the container

delete command does not delete an array that has open files

on it).

WARNING: Unconditionally deleting an array that is in use

can cause a system crash under some circumstances.

Examples

Before deleting an array, use the container list command to

obtain information about any existing arrays. As the following

example shows, there is an array 0 (a multilevel volume set) on this

controller:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

F: 0 Volume 40.0MB NTFS

63 Volume 10.0MB 0:02:0 64.0KB: 10.0MB

62 Volume 15.0MB 0:02:0 64.0KB: 10.0MB

61 Volume 15.0MB 0:04:0 64.0KB: 10.0MB

The following example shows how to delete array 0 using the /

always switch to indicate a delete even though the array has a file

system:

AAC0>container delete /always=TRUE 0

Executing: container delete /always=TRUE 0

Use the container list command after using the container

delete

command to confirm that the command actually deleted

the specified array, as in the following example:

AAC0>container list

Executing: container list

No containers found.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 353 354

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 89