Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 267)

11-3

enclosure Commands

enclosure activate slot

To activate a device in a specified slot of the specified SAF-TE

enclosure management device, use the enclosure activate

slot command. Specifically, this command makes the device that

resides in the slot available on the SCSI channel.

Syntax

enclosure activate slot {enclosure} {slot}

Parameters

{enclosure}

Specifies the ID associated with the enclosure management

device on which you want to activate a device. For this version,

the controller supports a maximum of eight enclosure

management devices on each bus.

{slot}

Specifies the unit number associated with the slot. This is the

slot that contains the device you want to activate. This unit

number can range from 0 to 15 inclusive. Typically, the slot

unit number is limited by the physical number of device slots

in the enclosure management device.

Examples

Before activating a device, you might want to use the enclosure

show slot command to determine the current device state.

As the following example shows, the current device state setting is

NOTACTIVATE:

AAC0>enclosure show slot 0

Executing: enclosure show slot 0

Enclosure Slot scsiId Insert Status

--------- ---- ------ ------- -----------------------------

0 0 0:00:0 4 OK UNCONFIG NOTACTIVATE

0 1 0:01:0 0 OK UNCONFIG ACTIVATE

0 2 0:10:0 0 OK UNCONFIG ACTIVATE

0 3 0:03:0 0 OK UNCONFIG ACTIVATE

0 4 0:04:0 0 OK UNCONFIG ACTIVATE

1 0 1:00:0 0 OK CONFIG ACTIVATE

1 1 1:01:0 0 OK UNCONFIG ACTIVATE

1 2 1:10:0 0 OK UNCONFIG ACTIVATE

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 353 354

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 267