Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 143)

5-95

container Commands

/wait{=boolean}

Specifies whether the command performs the scrub action

synchronously or asynchronously. If you set this switch to

TRUE, the command performs the scrub action synchronously,

which means the command prompt does not return until the

scrub action completes. If you set this switch to FALSE, the

command performs the scrub action asynchronously, which

means the command prompt returns immediately.

Examples

Before scrubbing a redundant array, use the container list

command to obtain information about any existing arrays. As the

following example shows, there is an array 0 (a mirror set) on this

controller:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

D: 0 Mirror 10.0MB NTFS 0:02:0 64.0KB: 10.0MB

0:02:0 10.0MB: 10.0MB

The following example synchronously scrubs array 0 using a delay

time of 5 milliseconds:

AAC0>container scrub /io_delay=5 /wait=TRUE 0

Executing: container scrub /io_delay=5 /wait=TRUE 0

As the command executes, note the title bar of the DOS window

displays the status of the command. For example:

Stat:OK!Task:100,Func:MSC Ctr:0,State:RUN 97.2%

See page 3-10 for detailed information on the status information that

the command displays in the title bar as it executes the task.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 353 354

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 143