Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 305)

11-41

enclosure Commands

enclosure show temperature

To display the temperature status of a specific temperature sensor

on a specific SAF-TE enclosure management device, use the

enclosure show temperature command. You can also use this

command to display the temperature status of all temperature

sensors on the enclosure management device or devices.

Syntax

enclosure show temperature [{enclosure}]

[{sensor}]

Parameters

{enclosure}

Specifies the ID associated with the enclosure management

device for which you want to display temperature status

information. For this version, the controller supports a

maximum of eight enclosure management devices on each

bus.

If you do not specify an ID, the command displays the

temperature status information for all enclosure management

devices connected to the controller.

{sensor}

Specifies the unit number associated with the temperature

sensor whose status you want to display. This integer can

range from 0 to 15 inclusive.

If you do not specify a unit number, the command displays the

status for all temperature sensors on the enclosure

management device or devices.

Examples

The following example displays the temperature status of

temperature sensor unit 0 on enclosure management device 0:

AAC0>enclosure show temperature 0 0

Executing: enclosure show temperature 0 0

Enclosure Sensor Temperature Threshold Status

--------- ------ ----------- --------- --------

0 0 70 120 NORMAL

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 353 354

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 305