Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 117)

100

101

5-69

container Commands

container promote

To create a multilevel volume set from a stripe set or volume set, use

the container promote

command. In this case, the resulting

array is an array of single-partition volume sets, each of which has a

single partition from the original array.

Typically, you use the container promote

command as part of a

process to provide fault tolerance for existing volume sets. After

container promote is executed, use container create

mmirror (which provides the fault tolerance) to make this array an

array of mirror sets.

Notes

The container promote command differs from the container

add_level

command as follows:

■ The container create volume command creates a single-

level array.

■ If you use the container add_level command and specify

the ID for a single-level volume set, the result is a volume set

with two partitions.

■ If you use the container promote command and specify

the ID for a single-level volume set, the result is a multilevel

volume set (a volume set with two volumes under it).

Syntax

container promote {container}

Parameters

{container}

Specifies the ID number (0 to 63) of the array to promote into a

multilevel array.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 353 354

Comentarios a estos manuales

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 117

Comentarios a estos manuales

Relacionado con productos y manuales para Software Adaptec 2120S - SCSI RAID Controller