Adaptec 2120S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 193)

6-21

controller Commands

controller set array_verify

To enable or disable the array verify operation, use the

controller set verify command. This command allows you

to enable or disable the array verify operation for all arrays

controlled by the specified controller.

Syntax

controller set array_verify

[/verify_enabled{=boolean}]

/verify_enabled{=boolean}

Specifies whether to turn on or off the array verify feature on

the specified controller. You must set this switch to TRUE if

you want to turn on array verify for all arrays associated with

the specified controller.

To turn off the array verify feature on the specified controller,

set this switch to FALSE. The command defaults to TRUE,

which means the command turns on the array verify feature

on the specified controller.

Examples

Before turning the array verify feature on or off, check its status by

using the controller show array_verify command. The

following example shows that the controller’s array verify feature is

currently off (disabled):

AAC0> controller show array_verify

Executing: controller show array_verify

Array verify DISABLED

The following example turns on (enables) the array verify feature for

the currently opened controller:

AAC0> controller set array_verify /verify_enabled

Executing: controller set array_verify /verify_enabled=TRUE

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 353 354

Sin comentarios

Adaptec 2120S - SCSI RAID Controller Guía de usuario Pagina 193