Adaptec AHA-1532P Guía de usuario descargar pdf (Pagina 96)

Appendix A: Additional Tasks88

• The BIOS is upgraded to a BIOS that supports larger drives.

• The destination drive is a SCSI drive that is larger than 504 MB.

Steps

Leave the source drive set as the master.

Install the destination drive and set it as drive 0.

Run the BIOS and auto-detect the drives.

Make sure that LBA is off for the source drive.

Run the SCSI BIOS to make sure the SCSI drive is recognized correctly.

Restart the computer and allow the drive overlay program to load.

Put your Drive Image bootable diskette in your diskette drive (A:).

In the drive overlay boot menu, select the option to boot from a floppy disk.

Make sure that Drive Image is showing the correct size for each drive and the correct

order for the copy sequence.

Finish the copy process.

Scenario 4

• The system has a BIOS that does not support drives over 504 MB in size.

• The source drive is an IDE drive larger than 504 MB and a drive overlay program is

installed.

• The BIOS is upgraded to a BIOS that supports larger drives.

• The destination is an IDE drive that is larger than 504 MB.

Steps

Set the source drive as the master.

Set the destination drive as the slave.

Run the new BIOS and auto-detect the drives.

Make sure that LBA is turned on for the destination drive and off for the source drive.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 127 128

Sin comentarios

Adaptec AHA-1532P Guía de usuario Pagina 96