PowerQuest Drive Image 87
4
Restart the computer again, allowing the drive overlay program to load.
5
Put your Drive Image bootable diskette in your diskette drive (A:).
6
In the drive overlay boot menu, select the option to boot from a floppy disk.
7
Make sure that Drive Image is showing the correct size for each drive and the correct
order for the copy sequence.
8
Finish the copy process.
Scenario 2
• The system has a BIOS that does not support drives over 504 MB in size.
• The source drive is an IDE drive larger than 504 MB and a drive overlay program is
loaded.
• The destination is a SCSI drive and will not need a drive overlay program.
Steps
1
Leave the source drive set as the master.
2
Install the SCSI drive with the lowest SCSI ID in the SCSI chain.
3
Run the BIOS auto-detect and make sure it recognizes the IDE drive.
4
Run the SCSI BIOS to make sure the SCSI drive is recognized correctly.
5
Restart the computer and allow the drive overlay program to load.
6
Put your Drive Image bootable diskette in your diskette drive (A:).
7
In the drive overlay boot menu, select the option to boot from a floppy disk.
8
Make sure that Drive Image is showing the correct size for each drive and the correct
order for the copy sequence.
9
Finish the copy process.
Scenario 3
• The system has a BIOS that does not support drives over 504 MB in size.
• The source drive is an IDE drive larger than 504 MB and a drive overlay program is
installed.
Comentarios a estos manuales