Adaptec 9210LP Guía de instalación descargar pdf (Pagina 30)

Adaptec Fibre Card 9210LP

When the installation is completed, remove the disk and rebuild

the kernel by typing the command:

# /etc/conf/bin/idbuild -B

Press Enter.

Verify the correct driver is installed by typing the command:

# pkginfo -1 afc9xxx

Reboot the system to make sure the system boots correctly. Type

the command:

# init 6

The following sequences will happen after the init 6

command is issued:

• Terminates running services.

• Save your /stand/unix to /stand/unix.old then

• copy the new kernel from /etc/conf/cf.d/unix to /stand/unix.

• reboot system.

Removing the Driver

To uninstall the Adaptec Fibre Channel driver:

Start UnixWare and login as root.

From the UnixWare console, type this command:

# pkgrm afc9xxx

Press Enter.

This message will appear:

Do you want to remove this package [yes,no,?,quit]?

Type Yes

Press Enter.

STEP 3

STEP 4

STEP 5

Remember that UnixWare commands are case sensitive.

Enter the commands exactly as shown.

NOTE

STEP 1

STEP 2

9210IG.book Page 29 Monday, April 2, 2001 11:13 AM

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Sin comentarios

Adaptec 9210LP Guía de instalación Pagina 30