Adaptec 9210LP Guía de instalación descargar pdf (Pagina 27)

Installation Guide

If you try to use a value less than 10 Sec OR greater than 90

Sec, driver will display the warning shown below and will

load with default value of 45 Seconds.

AFC9XXX: Invalid timeout parameter

AFC9XXX: Default timeout value of 45 Sec will be used

• LUN Support Description:

Maximum luns in PERIPHERAL_DEVICE_ADDRESSING

mode our driver supports are 255(0...254) and For EMC in

volume set addressing mode it supports 256(0...255).

Installing the Driver When Installing UnixWare

To Install the Adaptec Fibre Channel driver at the same time you

install UnixWare, follow these instructions:

Either insert the installation floppy disk of the UnixWare package

into the boot floppy disk drive or insert the installation CD into a

bootable CD-ROM. Reboot your computer.

Wait for the first UnixWare installation screen and prompt to

appear, then follow the on-screen instructions.

When prompted to either Install Host Bus Adapter Drivers or

Continue Installation, first, remove the Install disk if you are

using an installation boot disk, then select Install Host Bus

Adapter Driver.

Insert the Adaptec Fibre Channel driver disk for UnixWare 7.1.x

into the primary floppy disk drive and press Enter (you cannot

load drivers from a secondary floppy disk drive).

As the driver loads, a message identifying the installed host

adapter briefly appears on screen.

INSTALLING THE ADAPTEC FIBRE CARD 9210LP

EVICE DRIVER FOR UNIXWARE

STEP 1

STEP 2

STEP 3

9210IG.book Page 26 Monday, April 2, 2001 11:13 AM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 36 37

Sin comentarios

Adaptec 9210LP Guía de instalación Pagina 27