Adaptec 9210LP Guía de instalación descargar pdf (Pagina 26)

Adaptec Fibre Card 9210LP

Updating the Driver

To update the driver:

Perform the Unload procedure and make a backup of the old

driver. See Unloading the Driver on page 24.

Perform the Load procedure. See Loading the Driver on an

Existing NetWare Server on page 23.

Additional Notes

• During initial OS installation, do not install the OS on a

device attached to the Adaptec Fibre Card 9210LP. Currently,

AFC9XXX.HAM does not support booting off a Fibre Chan-

nel drive, but the SYS Volume may be installed to a Fibre

Channel device.

• Do not use SGSCSI.CDM from the redbox CDM. Use

SCSIHD.CDM for all drives.

• The AFC9XXX.HAM will support up to 124 FC-AL devices

under Novell NetWare.

• When using CP4100 Mux from CrossRoads with the ADIC

Tape library use firmware revision (9816D) or later on the

CP4100.

• By default the HBA port is initialized as an NL port when

connected to the fabric switch. To initialize the HBA port as

an N_port when connecting to the fabric switch load the

HAM driver using the following switch option: load

AFC9XXX.HAM initasnport=1.

• Description of TIMEOUT parameter:

Timeout parameter is provided to timeout the requests to a

desired value in seconds between [10,90] seconds. If you

don't specify it the default value of 45 seconds will be used

while loading driver. One can specify this parameter as:

LOAD AFC9XXX TIMEOUT=XX <RETURN>

Where XX is a value between 10 and 90.

STEP 1

STEP 2

9210IG.book Page 25 Monday, April 2, 2001 11:13 AM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 36 37

Sin comentarios

Adaptec 9210LP Guía de instalación Pagina 26