Adaptec 9210LP Guía de instalación descargar pdf (Pagina 16)

Adaptec Fibre Card 9210LP

Installing the Driver When Installing Windows 2000

The Adaptec Fibre Card 9210LP driver is not embedded on the

Windows 2000 installation disks (or CD-ROM) and must be

added during Windows 2000 installation. See your operating

system documentation for instructions.

Completing a Fresh Windows 2000 Installation From

CD-ROM or Floppy Disk

Start your system with the Windows 2000 CD-ROM in the

CD-ROM drive. (If you are installing from floppy disk, insert the

Windows Boot Disk into the floppy disk drive instead of the

Windows 2000 CD-ROM.)

You might see a message:

Press any key to boot from CD.

You will have five seconds to press a key to boot off the CD.

Press F6 when this message is displayed:

Press F6 if you need to install a third party SCSI or RAID

driver...

INSTALLING THE ADAPTEC FIBRE CARD 9210LP

EVICE DRIVER FOR WINDOWS 2000

In order to boot the operating system from a drive

attached to the Adaptec Fibre Card 9210LP, the Adaptec Fibre

Card 9210LP must be connected to a drive without a Fibre

Channel switch attached.

NOTE

STEP 1

When using a CD-ROM drive to install Windows 2000

from a bootable CD-ROM, make sure Bootable CD-ROM

support is enabled in either the system or SCSI BIOS setup

utility. If these options are not available, use the Windows

2000 floppy disks to boot from.

NOTE

STEP 2

STEP 3

9210IG.book Page 15 Monday, April 2, 2001 11:13 AM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Sin comentarios

Adaptec 9210LP Guía de instalación Pagina 16