Adaptec 9210LP Guía de instalación descargar pdf (Pagina 28)

Adaptec Fibre Card 9210LP

If you have additional HBA disks, insert the next HBA disk, select

Install Another HBA Disk, and press Enter.

If all of your HBA disks have been installed, remove the last HBA

disk, select Continue Installation, and press Enter.

If necessary, enter the Device Configuration Utility (DCU) to

view/change the UnixWare device configuration data.

Follow the on-screen instructions to continue with installation.

Refer to the UnixWare documentation and on-screen help files

for help in selecting options.

If your installation fails, go to the h screen to check for any error

messages printed.

Type Alt PrintScreen at the same time then type h.

You should see something similar to the following if the Adaptec

Fibre Channel driver has been loaded.

0:0, 0, 0: HBA : (afc9xxx, 1) Adaptec AFC9xxx

0, 2, 0: DISK : SEAGATE ST318304FC 0001

0, 3, 0: DISK : IBM DDYS-T18350 0002

Read printed messages if any. If your installation has failed, these

messages will help you to determine why it failed. Follow the

instructions in the UnixWare documentation and in this

Installation Guide to retry the installation.

Installing the Driver When UnixWare is Already

Installed

To update or install the Adaptec Fibre Channel driver on a system

where UnixWare is already installed, follow the instructions in

this section.

STEP 4

STEP 5

STEP 6

STEP 7

Improper or corrupt driver updates might destroy

your existing UnixWare file system. Back up all important

files before proceeding. Consult your UnixWare

documentation for proper backup procedures.

CAUTION

9210IG.book Page 27 Monday, April 2, 2001 11:13 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

Sin comentarios

Adaptec 9210LP Guía de instalación Pagina 28