Adaptec AHA-2930CU Guía de instalación descargar pdf (Pagina 55)

Operating 47

VIDAR Film Digitizer Installation Guide

Scanning a single film

Options for scanning single films

There are two ways to scan a single film:

 By manually inserting the film behind the blue area (as

described in this section), or

 By treating the single film as a batch of one (if the scanning

application supports this approach); for instructions, see

“Scanning multiple films” (next section in this manual).

The digitizer cannot scan films smaller than 5" x 7" (12.7cm x

17.8cm).

1. Hold the film in front of you as you

would view it on a light box.

2. Align the left edge of the film with

the film guide on the left of the

feeder.

3. Place the film into the slot

BEHIND the blue area.

The blue area is defined by a lip

and a groove on the top edge of the

digitizer where the feeder is

attached. Place a single film

directly behind the the blue area.

When the digitizer senses the film,

it automatically stages the film in preparation for digitizing. The film

will first move down, then up. This is normal operation.

CAUTION: If the film is not staged properly, do not manually

pull the film out of the digitizer. Instead, use the scanning

application’s “eject” command to remove the film.

continued

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Sin comentarios

Adaptec AHA-2930CU Guía de instalación Pagina 55