Adaptec 2110S - SCSI RAID Controller Guía de instalación descargar pdf (Pagina 42)

3-7

Installing the Driver

Installing the Driver in a New System with Only One

Controller

In this scenario, you are installing an Adaptec RAID controller and

Windows NT 4.0 in a new system that does not have other hardware

that requires the use of Windows NT mass storage detection.

Note: If Windows NT is to coexist with another operating

system, the other operating system must be installed before

you install Windows NT.

To install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

2 Start up the system. During startup, press Ctrl+A to start

SMOR. Use SMOR to create the RAID. For details, refer to

Using SMOR on page 2-11.

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

4 Shut down the system and remove the Adaptec RAID

Installation CD and the driver floppy disk.

5 Insert the Windows NT setup media (floppy disk or CD) and

restart the system.

6 Press F6 when the “Inspecting your computer hardware”

screen appears.

7 Press S to Specify Additional Devices.

COMBINED RAID IG.BOOK Page 7 Tuesday, September 25, 2001 5:46 PM

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 105 106

Sin comentarios

Adaptec 2110S - SCSI RAID Controller Guía de instalación Pagina 42