Adaptec 2110S - SCSI RAID Controller Guía de instalación descargar pdf (Pagina 37)

3-2

Adaptec RAID Installation Guide

Windows 2000

The following sections describe procedures for installing the

Adaptec RAID controller with Windows® 2000. The following

installation scenarios are described:

■ Installing the Driver in a New System on page 3-2

■ Adding the Controller to an Existing System on page 3-4

■ Upgrading Windows NT to Windows 2000 on page 3-5

Caution: When adding a Zero Channel RAID (ZCR)

controller to an existing system, backup all data from

system drives prior to the installation. If the boot device is

connected to one of the onboard SCSI channels, the

operating system will need to be reinstalled after installing

the ZCR controller.

Note: The Adaptec driver for Windows 2000 does not

include a digital signature. Your system may display

warning messages about this condition. Bypass the

warnings and continue with the installation. The driver will

function normally when the upgrade or installation is

complete.

Installing the Driver in a New System

In this scenario, you are installing the Adaptec RAID controller in a

new system that has no operating system. To install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

COMBINED RAID IG.BOOK Page 2 Tuesday, September 25, 2001 5:46 PM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

Sin comentarios

Adaptec 2110S - SCSI RAID Controller Guía de instalación Pagina 37