Adaptec 2110S - SCSI RAID Controller Guía de instalación descargar pdf (Pagina 30)

2-7

Installing Your Controller

Seating the Module

–

Adaptec 3200S/3400S Only

Holding the circuit board and module by the edges, slide the

module into the socket as shown below. Refer to Appendix A for

socket locations.

From the side view shown in the circled areas at the bottom, you can

see that the module is placed into the socket at an angle. Then, press

the module into place until the metal clips click into the sides of the

module and hold it securely.

COMBINED RAID IG.BOOK Page 7 Tuesday, September 25, 2001 5:46 PM

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 105 106

Adaptec RAID 1
Copyright 2
Trademarks 2
Disclaimer 2
Adaptec, Inc 3
Canadian Compliance Statement 4
Contents 5
3 Installing the Driver 6
A Card and Module Diagrams 8
B Controller LEDs 8
C Troubleshooting 8
E Specifications 8
System Requirements 10
Kit Contents 11
About the Documentation 14
Introduction 15
Files and Folders 16
Product Documentation on CD 16
Errata and Release Notes 17
Cache Memory Module 19
Safety Information 22
Installing Your Controller 24
Configuring SCSI Devices 25
LVD and SE Devices 26
SCSI Cables 26
SCSI Device IDs 26
SCSI Termination 27
Seating the Module 30
Adaptec 3200S/3400S Only 30
Installing the Controller 32
Using SMOR 34
Installing the Driver 36
Windows 2000 37
Windows NT 4.0 41
Controller 42
5 Select Adaptec I 46
8 Start up the system 46
Creating the Driver Disk 47
C drive 48
(OEM SR2 – Version 95B) 50
Novell NetWare 54
NetWare 4.11 Server 55
NetWare 4.2 Server 57
C drive named nwupdate 58
NetWare 5 Server 60
SCO UNIX 62
Installing Storage 69
Management Software 69
Installation Prerequisites 71
NetWare 4.11 and 4.2 72
NetWare 5.x 74
Red Hat Linux and FreeBSD 75
Installing Storage Manager 76
SCO UnixWare 7 78
■ K Desktop Environment (KDE) 79
Card and Module Diagrams 80
Adaptec ATA RAID 2400A 81
Adaptec SCSI RAID 2000S 82
Adaptec SCSI RAID 2005S 83
Adaptec SCSI RAID 2100S 84
Adaptec SCSI RAID 2110S 85
Adaptec SCSI RAID 3200S 86
Adaptec SCSI RAID 3400S 87
Adaptec SCSI RAID 3210S/3410S 88
Controller LEDs 92
LED During Power-up 93
LEDs During Controller Idle 93
LEDs During Controller Active 93
Cache Status LEDs 94
SCSI Bus Status LEDs 95
Troubleshooting 97
Controller Reset Procedures 101
NVRAM Reset 102
Flash Mode 0 102
Specifications 104
RINTED IN SINGAPORE 106

Comentarios a estos manuales

Sin comentarios

Adaptec 2110S - SCSI RAID Controller Guía de instalación Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Placas base Adaptec 2110S - SCSI RAID Controller