Adaptec AHA-1540CP Guía de usuario descargar pdf (Pagina 92)

6-10

Adaptec 7800 Family Manager

2 Check the host adapter BIOS messages to verify that all your

installed SCSI devices are listed.

If some or all of your installed SCSI devices do not appear at this

time, your SCSI cables may be loose, or the SCSI device setup may

not be complete. If so, go back and correct any problem before

proceeding.

3 Wait for UNIX to complete bootup with the new kernel.

Refer to Troubleshooting on page 6-13 if the system crashes or if

panic (UNIX error) messages are displayed during bootup.

The

alad

alad325

driver for your 7800 Family host adapter should now be

ready for use.

Using SCO UNIX and the Host Adapter

This section contains useful information on using SCO UNIX and your

host adapter.

Using Multiple Host Adapters

If you are adding an additional 7800 Family host adapter to a system with a

7800 Family host adapter already installed, follow the instructions in the

SCO UNIX documentation for adding devices using the mkdev command.

When the system asks for the host adapter prefix, type alad or blad and

press Enter.

Changing the Boot Disk

If you are changing the boot device from a non-SCSI hard disk to a SCSI

hard disk attached to an Adaptec 7800 Family host adapter, you must

reinstall SCO UNIX.

If you are already booting from a SCSI hard disk and wish to boot from a

SCSI hard disk attached to an Adaptec 7800 Family host adapter, you may

elect to either reinstall SCO UNIX with the new driver (see Installing the

Driver When Installing SCO UNIX on page 6-2), or update SCO UNIX

with the new driver (see Installing the Driver When SCO UNIX is Already

Installed on page 6-5).

Using Wide SCSI Host Adapters and Devices

SCO UNIX 3.2v4.2, SCO ODT 3.0, and SCO OpenServer 3.0 support

SCSI IDs 0 to 7; SCSI IDs greater than 7 are not recognized. If your 7800

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 119 120

Sin comentarios

Adaptec AHA-1540CP Guía de usuario Pagina 92