Adaptec AHA-1540CP Guía de usuario descargar pdf (Pagina 114)

7-14

Adaptec 7800 Family Manager

[xxxxx047] Command aborted

An internal condition caused the driver to abort the command. In most

cases, the command is retried and is recovered, and normal operation

continues.

[xxxxx048] Unable to abort command

An error occurred while aborting a command. Possibly, the command has

already completed and there is nothing to abort.

[xxxxx049] Command abort in progress

This indicates an abort command has been issued. This is a normal

operating condition.

[xxxxx051] Target device did not respond to reset sequence

The target device did not reset correctly as requested by the driver.

Normally, this indicates a faulty or non-compliant target device.

[xxxxx081] Adapter Initialization Failure

An error has occurred while the driver was setting up its internal data

structures. Verify that your adapter is supported by this version of the

driver.

[xxxxx083] Adapter not supported by this version of the driver

Your adapter is not supported by the driver on your system. You may have

installed a new adapter and have not updated the driver on your system.

[xxxxx096] Adapter hardware initialization failure - possible resource

conflict

The driver has attempted to initialize the adapter hardware but failed. This

might suggest that the adapter resources (e.g., IRQ) conflict with another

board installed in your system.

[xxxxx097] Unable to allocate memory

This indicates that there may be a problem with the amount of memory

installed in your system. Verify that your system has at least the minimum

amount of memory required by your operating system.

[xxxxx098] Exceeded maximum number of host bus adapters

The driver has detected more host bus adapters than is supported by this

version of the driver or operating system.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 120

Sin comentarios

Adaptec AHA-1540CP Guía de usuario Pagina 114