
4-19
Novell NetWare Installation
[xxxxx087] Internal driver error
An error has occurred while the driver was setting up its internal data
structures. Try installing the most up-to-date version of the driver available
from the Adaptec Web site or BBS.
[xxxxx088] Adapter software initialization failure
An error has occurred while the driver was setting up its internal data
structures. Try installing the most up-to-date version of the driver available
from the Adaptec Web site or BBS.
[xxxxx089] Unable to allocate memory
This indicates that there may be a problem with the amount of memory
installed in your system. Verify that your system has at least the minimum
amount of memory required by your operating system.
[xxxxx096] Adapter hardware initialization failure - possible resource
conflict
The driver has attempted to initialize the adapter hardware but failed. This
might suggest that the adapter resources (e.g., IRQ) conflict with the
resources of another board installed in your system.
[xxxxx099] Adapter software initialization failure
[xxxxx09a] Adapter software initialization failure
[xxxxx09b] Adapter software initialization failure
An error has occurred initializing one of the driver’s internal data structures
for a device connected to the adapter. This may result in problems
accessing the device. Try installing the most up-to-date version of the driver
available from the Adaptec Web site or BBS.
[xxxxx0ab] Driver already loaded for this host bus adapter
The driver is already loaded for this adapter. Verify that the correct adapter
is specified in your command line or startup file.
[xxxxx0ac] Driver already loaded for all host bus adapters
The driver is already loaded for all the supported adapters in this system.
[xxxxx0a4] SCSI bus reset by third party hardware
Hardware such as an array enclosure may have reset the SCSI bus. This is a
normal condition unless you receive additional errors.
Comentarios a estos manuales