Adaptec AHA-1540CP Guía de usuario descargar pdf (Pagina 21)

2-3

Microsoft Windows NT Installation

Note: If you are installing an Ultra2 SCSI host adapter

such as the AHA-2940U2W, you cannot select Express

setup, because the

aic78u2.sys

driver is not embedded.

Selecting Express setup loads the embedded driver

aic78xx.sys

included with Windows NT which is for Ultra

SCSI adapters only.

Press S to skip mass storage device detection. This allows you to

manually select the driver for your host adapter.

Since mass storage device detection was skipped in the previous step,

Windows NT Setup displays none in the list of recognized devices.

Press S to configure additional SCSI adapters.

From the list of additional SCSI adapters, expand the list, select

Other, and press Enter (requires disk provided by a hardware

manufacturer).

Insert the Adaptec 7800 Family Manager Set diskette for Windows

NT into drive A

and press Enter.

The screen displays the adapter drivers supported on the diskette. For

Windows NT 3.5x, the following is displayed:

Adaptec AHA-290x/291x/294x/4944/AIC-78xx PCI SCSI

Controller (NT 3.5x)

Adaptec AHA-294xu2/AIC-7890/91 PCI Ultra2 SCSI Controller

(NT 3.5x)

Highlight the driver and press Enter.

To add other host adapters that are not a part of the 7800 Family, do

so at this time by repeat from step 7 for each additional adapter and

insert the appropriate driver disk. The Adaptec 7800 Family host

adapters use the same driver; it is not necessary to install the driver

again.

Press Enter to continue with the Windows NT operating system

setup. Follow the instructions given onscreen and in the Windows NT

installation documentation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 119 120

Sin comentarios

Adaptec AHA-1540CP Guía de usuario Pagina 21