Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario descargar pdf (Pagina 51)

100

101

3A-26 A-63054 February 2004

Setting up the scanner You can set up or change the parameters of the scanner you will be using by

accessing the Setup dialog box.

1. Select Scanner>Setup.

The Scanner Setup dialog box appears.

2. Enter a Transport Time-out value, if desired.

Valid values for the time-out period depend upon the attached scanner.

For the Scanner 3500, Scanner 3510, Scanner 3520, Color Scanner

3590C, and Color Scanner 4500, valid values are 3 to 30 seconds.

The Transport Time-out is the number of seconds that the scanner

transport remains enabled when not actively scanning. When a time-out

occurs, the scanner transport stops and is disabled.

3. Enable or disable the Lamp saver setting.

A check in the box indicates that Lamp saver is enabled; no check

indicates that it is disabled. In order for a change in the setting to take

effect, you must scan at least one page. When Lamp saver is enabled,

the lamps in the scanner automatically shut off after 10 minutes of scanner

inactivity. When this feature is disabled, the lamps in the scanner remain

on until the scanner is powered off.

NOTE: Transport Timeout and Lamp saver are only available in Capture

Software for the Scanner 3500, Scanner 3510, Scanner 3520, Color

Scanner 3590C, and Color Scanner 4500.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 411 412

Comentarios a estos manuales

Sin comentarios

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario Pagina 51

Comentarios a estos manuales