Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario descargar pdf (Pagina 339)

9B-8 A-63054 February 2004

Auto delete images—allows you to discard images below or above a byte

threshold during scanning. This is useful for automatically removing blank

sides (e.g., blank rears). The Auto-delete check is performed after any auto-

cropping, splitting, or merging that may take place.

NOTES: When enabled, auto-deletion will take place on all scanned images

(front and rear). This is different from the way auto-deletion works

with other Kodak scanners, where you can specify a different auto-

deletion setting for each side of a scanned page.

Auto-deletion is not available for Capture Software Lite for

i50/i60/i80 Scanners.

Mask tab

Mask coordinates define the area to be scanned. Values are expressed in

hundredths of an inch. By default, Capture Software comes with pre-defined

image settings for A4- and letter-size documents for both automatic document

feeder and flatbed scanning.

Draw mask—opens a scan window. Scan one page and draw a mask on the

image and click OK. Capture Software automatically calculates the mask

parameters and enters the value in the Left, Top, Width, and Height fields.

Depending on whether you are setting up the front or rear image, Capture

Software displays the image coming from the front or rear scanner.

NOTE: The Left field value you use will be different depending on whether you

are scanning with the feeder or the flatbed. When scanning from the

flatbed, documents are usually placed in the upper left corner of the

flatbed platen—the (0, 0) point. Therefore, the Left value will usually be

“0.” However, when scanning from the feeder where documents are

center-fed, the Left value must be adjusted based on the distance of

the document from the left side of the feeder transport.

• The maximum Width value is 8.5 in.

• The minimum Height value is 14 in. (14.27 in. for the i80 Scanner) for

feeder scanning and 11.7 in. for flatbed scanning.

• If a value greater than 11.7 in. is specified when flatbed scanning, Capture

Software automatically adjusts the setting to 11.7 in. prior to scanning.

• The combined values of the Left and Width fields should not exceed the

scanner’s maximum width of 8.5 in.

• The combined values of the Top and Height fields should not exceed the

scanner’s maximum height of 14 in. (14.27 in. for the i80 Scanner).

1 2 ... 334 335 336 337 338 339 340 341 342 343 344 ... 411 412

Sin comentarios

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario Pagina 339