Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario descargar pdf (Pagina 261)

100

101

6-8 A-63054 February 2004

Drawing and

selecting bar code

zones

Bar code zones are drawn in the Bar Code and OCR Setup window. Once you

define a bar code zone, you can set up the bar code properties. See the

following section for defining bar code zone properties.

To draw a bar code zone:

1. Select the Bar Code button in the Bar Code and OCR Setup Tool bar.

2. Place the mouse cursor at the top left corner of the area of the displayed

image where you want to define the bar code zone.

It is recommended that you draw the zone about a ¼-inch larger on all

sides than the actual bar code. This ¼-inch “quiet space” around the bar

code is often necessary for successful bar code reading. Bar code zones

can overlap.

NOTE: Bar code zones are application-specific; not image-specific. Therefore,

displaying a new image will continue to display the zones as defined.

3. Click the left mouse button and drag the cursor until a rectangle is drawn

around the area of the bar code.

• Bar codes defined with Zone will be enclosed in a red box.

• Bar codes defined with Anywhere will be enclosed in a blue box.

As the rectangle is drawn, the x and y coordinates and width and height

are displayed (in 1/100 in.) in the status bar at the bottom of the screen.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 411 412

Comentarios a estos manuales

Sin comentarios

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Guía de usuario Pagina 261

Comentarios a estos manuales