Adaptec 2100S - SCSI RAID Controller Guía de instalación descargar pdf (Pagina 63)

3-28

Adaptec RAID Installation Guide

4 To run the installpkg utility, type installpkg -d disk/.

SCO UNIX reads the disk and prompts you to enter the

package name to be installed.

5 Type dpti4 for Open Desktop 3.x and dpti5 for SCO

OpenServer 5.x.

6 After the package is installed, rebuild the kernel.

7 Restart the system.

8 Install the new kernel.

9 Add devices to the controller.

Adding the Controller to an Existing UnixWare 7 System

In this scenario, you are adding an Adaptec RAID controller to an

existing UnixWare 7 system. To install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

2 Download the latest I

O supplement for UnixWare 7 from the

SCO Web site—it should be

ptf7066c or higher.

3 Uncompress the PTF file you downloaded in Step 2 and move

the file to the

/tmp directory.

4 Use the pkgadd utility to install the I

O supplement by typing:

pkgadd -d /tmp/ptf7066c

5 Follow the on-screen prompts to install the SCO UnixWare I

supplement.

6 Shutdown and reboot the system.

Note: Upon restarting, several warning messages may

appear and scroll off the screen quickly. These will not occur

after diskadd is run and can be ignored.

7 Use the diskadd utility to add drives or arrays that are attached

to an Adaptec RAID controller.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

Sin comentarios

Adaptec 2100S - SCSI RAID Controller Guía de instalación Pagina 63