Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 63)

3-32

container Commands

container create volume

To create a volume set from freespace, use the container

create volume

command.

Notes

If you created a volume set you can run the list devices

command on the NetWare console to verify its creation and then

create the necessary NetWare disk partitions and volumes.

For information on how to create partitions and volumes, see the

appropriate NetWare documentation.

Syntax

container create volume [/cache{=boolean}] [/

label{=string}] {scsi_device},{free_space}

[{scsi_device},{free_space}...]

Parameters

{scsi_device}

Specifies the ID for the SCSI device whose freespace you want

to use for creating the volume set. A SCSI ID consists of a

SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0

through 15 inclusive), and SCSI device logical unit number (0

through 7 inclusive). See the installation guide for your

controller to determine the number of buses it actually

supports.

For further details, see scsi_device on page 1-10.

Note that you must explicitly specify the entire ID for the

SCSI device (the SCSI channel number, device ID, and device

logical unit number).

{free_space}

Specifies the freespace used to create the volume set on the

specified SCSI device.

For further details, see free_space on page 1-11.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 277 278

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 63