Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 126)

3-95

container Commands

container set failover

To assign an automatic failover disk(s) for a single array, use the

container set failover

command. If the array was already

assigned a failover disk(s), the command adds the specified disk(s)

to the array’s list of failover disk(s). Although all array types accept

failover assignments, only mirror set and RAID 5 array

(redundant) array types use the failover assignment if a disk fails.

Syntax

container set failover {container} {scsi_device}

[{scsi_device}...]

Parameters

{container}

Specifies the ID number (0 to 63) of the array on which to

assign an automatic failover disk(s).

{scsi_device}

Specifies the ID for the SCSI device that you want to assign as

a failover disk to the array specified in the

container

parameter. A SCSI ID consists of a SCSI channel number (for

example, 0, 1, 2, 3, etc.), a SCSI device ID (0 through 15

inclusive), and a SCSI device logical unit number (0 through 7

inclusive).

For further details, see scsi_device on page 1-10.

{scsi_device}...

Specifies the ID(s) for additional SCSI device(s) that you want

to assign as failover disk(s) to the array specified in the

container parameter.

Examples

Before assigning a SCSI device as a failover disk to an array, use the

container list

command to obtain information about any

existing arrays.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 277 278

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 126