Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 49)

3-18

container Commands

{container}...

Specifies the ID (0 to 63) of one or more additional arrays from

which you want to create the multilevel volume set. You can use

up to 16 arrays. Typically, the additional arrays you specify are

the same type as the first array. For example, if the first array is a

stripe set then any subsequent arrays are also stripe sets.

Switches

/label{=string}

Specifies a label to be assigned to the newly created

multilevel volume set. You can specify a maximum of sixteen

characters for the label.

If you do not specify the switch, it defaults to no label. If you

do not specify a label, you can do so later by using the

container set label command.

Examples

Before creating a multilevel volume set, use the container list

command to obtain information about any existing arrays.

As the following example shows, there are two existing arrays

(stripe sets) on this controller at the time the multilevel volume set

is created:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

0 Stripe 45MB 64KB None 0:02:0 64.0KB: 15.0MB

0:03:0 64.0KB: 15.0MB

0:04:0 64.0KB: 15.0MB

1 Stripe 15MB 64KB None 0:05:0 64.0KB: 15.0MB

The following example shows how to create a multilevel volume

set from two single arrays:

AAC0> container create mvolume 0 1

Executing: container create mvolume 0 1

container 0 created

On UNIX systems, the message displayed after you execute the

container create mvolume

command includes the root special

file associated with the newly created multilevel volume set.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 277 278

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 49