Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 58)

3-27

container Commands

container create stripe

To create a stripe set from freespace, use the container create

stripe

command.

Notes

If you created a stripe set you can run the list devices

command on the NetWare console to verify its creation and then

create the necessary NetWare disk partitions and volumes.

For information on how to create partitions and volumes, see the

appropriate NetWare documentation.

Syntax

container create stripe [/cache{=boolean}]

[/stripe_size{=integer}] [/label{=string}]

{free_space} [{scsi_device}...]

Parameters

{free_space}

Specifies the SCSI device and its associated freespace used to

create the stripe set.

For further details, see free_space on page 1-11.

{scsi_device}...

Specifies one or more SCSI devices. A SCSI ID consists of a

SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0

through 15 inclusive), and SCSI device logical unit number (0

through 7 inclusive). See the installation guide for your

controller to determine the number of buses it actually

supports.

For further details, see scsi_device on page 1-10.

The command uses the freespace(s) from the SCSI device(s) to

create the stripe set. The size from the device is identical to

the one you specify in the free_space

parameter.

The minimum number of partitions for a stripe set is 2, and

the maximum number is 16.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 277 278

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 58