Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 145)

3-114

container Commands

container unmirror

To unmirror a mirror set, resulting in a single-partition volume set

and freespace, use the container unmirror

command. Note

that there is no equivalent command for a multilevel array of

mirror sets. To unmirror a multilevel array of mirror sets, use this

command for each underlying mirror set.

Syntax

container unmirror {container}

Parameters

{container}

Specifies the ID number (0 to 63) of the mirror set to unmirror.

You previously created the mirror set by using the

container create mirror

or container create

mmirror

command.

Examples

Before unmirroring a mirror set, use the container list

command to obtain information about any existing arrays. As the

following example shows, there is one existing array (array 0, a

mirror set) on this controller at the time the mirror set is

unmirrored:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi

Dr Label Type Size Ctr Size Usage C:ID:L State

-- ----- ------ ------ --- ------ ------- -------- -----

0 Mirror 10.0MB NTFS 0:02:0 Normal

0:03:0

Note that the example eliminates some items in the container

list display so that you can see an example of the State column.

The following example shows how to unmirror a mirror set from

the mirror set that resides on SCSI device (0,3,0):

AAC0>container unmirror 0

Executing: container unmirror 0

Note that the example eliminates some items in the container

list display so that you can see an example of the State column.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 277 278

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 145