Adaptec SCSI RAID 2120S Guía de instalación descargar pdf (Pagina 50)

3-19

container Commands

Use the container list command after using the container

create mvolume command to display information about the

multilevel array of volume sets after you create it, as in the

following example:

AAC0>container list

Executing: container list

Num Total Oth Stripe Scsi Partition

Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size

-- ----- ------ ------ --- ------ ------- ------ -------------

0 Volume 60.0MB None

63 Stripe 45MB 64KB 0:02:0 64.0KB: 15.0MB

0:03:0 64.0KB: 15.0MB

0:04:0 64.0KB: 15.0MB

62 Stripe 15MB 64KB 0:05:0 64.0KB: 15.0MB

The following list describes the columns that contain information

as a result of creating a multilevel volume set with the container

create mvolume

command:

■ The Num Label column displays the ID number (in the

example, 0) of the newly created multilevel volume set and

(indented to the right) the ID numbers of the arrays that make

up the multilevel volume set. In the example, arrays 63 and 62

are the stripe sets that make up the multilevel volume set.

If you specify a label when creating the multilevel volume set,

it appears in this column. Because no label was specified

when the multilevel volume set was created, no label appears

in the column.

On UNIX systems, the root special file associated with the

multilevel volume set also appears in this column.

■

The

Type

column displays the type name

Vo l u m e

for the newly

created multilevel volume set. The

Type

column also displays

the array type for the underlying arrays. In the example,

Stripe

appears in the

Type

column to indicate that the arrays that

make up the multilevel volume set are stripe sets.

■ The Total Si z e column displays the total size for the

multilevel volume set. This size is the total of all the

underlying arrays. In the example, the total size for array 0

(the multilevel volume set) is the sum of the two underlying

arrays (60 MB).

The

Total Size

column also displays the sizes of all the

underlying arrays. In the example, the size of array 63 (45 MB)

and array 62 (15 MB) were specified when the stripe sets were

created with the

container create stripe

command.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 277 278

Comentarios a estos manuales

Sin comentarios

Adaptec SCSI RAID 2120S Guía de instalación Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Tarjetas de interfaz / adaptadores Adaptec SCSI RAID 2120S